harrypoon 發表於 2006-8-3 18:27:29

CJ Preamp -"Dee" sound, any help??

With guidance and patience of KK and William, I finally completed
my first DIY toy.   :)

However, there is a problem to be resolved – this is "dee" sound that existed before the output delay started, but once the output delay started, the "dee" sound disappeared.   :(

Any member have such problem, and know the solution :?:

KK,
Have you received by email sent this Monday?I've re-soldered the grounding to the output delay board, but the problem still exist.

Harry

kk_ho 發表於 2006-8-3 23:12:51

Re: CJ Preamp -"Dee" sound, any help??

Harry,

Let me check my reference in hififever office at coming SUN.
Will let you know the result soon.


KK.


With guidance and patience of KK and William, I finally completed
my first DIY toy.   :)

However, there is a problem to be resolved – this is "dee" sound that existed before the output delay started, but once the output delay started, the "dee" sound disappeared.   :(

Any member have such problem, and know the solution :?:

KK,
Have you received by email sent this Monday?I've re-soldered the grounding to the output delay board, but the problem still exist.

Harry

harrypoon 發表於 2006-8-5 10:57:51

KK,

Thanks, and await your advice.

This morning, I removed the output delay and connect direct to the RCA output pin.The "dee" sound disappeared.So, it appears the problem is with the output delay.

Harry

kk_ho 發表於 2006-8-5 12:17:06

Harry,

Not the delay board, I know what happen, will test at Sunday.

Will let you know ASAP.

I cannot test it at my home because all equipement send to HF APM office.

KK



KK,

Thanks, and await your advice.

This morning, I removed the output delay and connect direct to the RCA output pin.The "dee" sound disappeared.So, it appears the problem is with the output delay.

Harry

harrypoon 發表於 2006-8-7 09:53:59

KK,

Yesterday was in hurry.So, I better recap what should be done.

From the output (i.e. the part soldered to the RCA output), solder a 47k resistor, and connect the resistor to ground.Questions :-

(1) Both channels are connected to the same grounding point - am I correct?

(2) Do I need to use two 47k resistors - i.e. one for each channel, or just connect both channels to one 47k resistors?

You've mentioned the possible damage that could cause without output delay design, but I've forgotten the reason.Can you explain the reason once more?

Thanks
Harry
頁: [1]
查看完整版本: CJ Preamp -"Dee" sound, any help??